Read raw barcode / transponder
With this function, the data of a barcode or an RFID transponder can be read. Unlike the normal read function, this function does not interpret the data. Therefore, it is not required that it is a valid GS1 barcode or RFID transponder. It just reads the raw data. The data is sent via Bluetooth to a computer and can be viewed there.
Procedure
The button to use this function can be set in the configuration.
By default, this function is not mapped on any button.
The device must be switched on. A Bluetooth connection to a PC must be established. Open a simple text program on the PC. The read data will then be written directly into it.
Press and release the configured button. The yellow LED will light up and a short bright tone will sound.
First the device tries to read an RFID transponder. If, after a short time, no transponder is found, the barcode scanner is activated. As soon as one of them is detected, the data is sent to the PC.
If no transponder or barcode is found, this is signaled with three consecutive tones.